Traulsen Freezer RFF132WUT FHS User Manual

Project  
Quantity  
Item #  
Model Specified:  
CSI Section 11400  
Reach-In Fast Freezer Models/  
One, Two & Three Section Reach-In Models - 32" Deep  
Self-Contained  
1-Section Full Length Door Model  
2-Section Full Length Door Model  
3-Section Full Length Door Model  
1-Section Half Length Door Model  
2-Section Half Length Door Model  
3-Section Half Length Door Model  
RFF132WUT-FHS  
RFF232WUT-FHS  
RFF332NUT-FHS  
RFF132WUT-HHS  
RFF232WUT-HHS  
RFF332NUT-HHS  
R
SERIES  
Stainless Exterior  
& Interior  
INTELA-TRAUL®  
Equipped!  
The R-Series Fast Freezer line is designed to allow on premise, small-  
scale fast freezing. To accomplish this, a -20 degree F air temperature  
is utilized, along with sufficient air movement to promote rapid heat trans-  
fer from the product. These models are supplied standard with all the  
Traulsen top of the line features, such as balanced refrigeration sys-  
tems, next generation INTELA-TRAUL® controls and stainless steel  
exteriors and interiors.  
Model RFF232WUT-FHS  
Standard Product Features  
Options & Accessories  
Stainless Steel Exterior & Interior  
Stainless Steel Finished Back With Rear Louvers  
Re-Hinging Feature For Door(s)  
INTELA-TRAUL® Microprocessor Control System  
Balanced, Self-Contained Refrigeration System Using  
R-404A Refrigerant  
No. 1 Type Tray Slides To Accommodate either (1) 18" x 26"  
or (2) 14" x 18" Sheet Pans, Adjustable To 2" O.C.  
No. 2 Type Tray Slides To Accommodate (1) 18" x 26" Sheet  
Pans, Adjustable To 2" O.C.  
No. 3 Type Tray Slides To Accommodate (2) 12" x 20" Steam  
Table Pans, Adjustable To 2" O.C.  
No. 4 Type Tray Slides To Accommodate (1) 18" x 26" Sheet  
Pans (chrome rod type, equips 1/2 section)  
Universal Type Tray Slides To Accommodate Either (1)  
18" x 26" or (2) 14" x 18" Sheet Pans, or (2) 12" x 20" Steam  
Table Pans, Adjustable To 4" O.C.  
Full or Half Length Stainless Steel Doors With Locks  
Self-Closing Doors With Stay Open Feature At 120 Degrees  
Guaranteed For Life Cam-Lift Hinges  
Guaranteed For Life Horizontal Work Flow Door Handle  
Standard Door Hinging: 132W = Right, 232W = Left/Right,  
332N = Left/Right/Right (other hingings available)  
Automatically Activated Incandescent Lights  
Stainless Steel Breaker Caps  
Three Chrome Plated Adjustable Shelves Per Section,  
Supported On Shelf Pins (installed at the factory)  
Automatic Bottom Mounted Electric Condensate Evaporator  
Magnetic Snap-In Door Gaskets  
Gasket Protecting Stainless Steel Door Liner  
Controllable Anti-Condensate Door Perimeter Heaters  
Thermostatic Expansion Valve Metering Device  
Stainless Steel One-Piece Louver Assembly  
9' Cord & Plug Attached (one section models only)  
Set of Four (4) 6" High Adjustable Stainless Steel Legs  
One Year Parts And Labor Warranty  
Additional Chrome Plated Shelves  
Locking Hasps (padlocks supplied by others)  
Stainless Steel Shelves In Lieu of Standard Chrome Plated  
Kool Klad Exterior Laminate Decor  
Set of Four (4) 6" High Casters In Lieu of Legs  
Set of Four (4) 4-5/8" High Casters In Lieu of Legs  
4-1/2" High Stainless Steel Base In Lieu of Legs  
6" High Stainless Steel Kickplate (for use with standard legs)  
Prison/Correctional Facilities Options  
Remote Applications (see spec sheet 12-2 for more details)  
Two Year Service/Labor Warranty Available  
Two Year Control Warranty (parts and labor)  
Five Year Compressor Warranty  
Listed by Underwriters Laboratories Inc., to  
U.S. and Canadian safety standards and  
Listed by NSF International.  
Approval: __________________________________  
TRAULSEN  
4401 BLUE MOUND RD.  
PHONE 1 (800) 825-8220  
FT. WORTH, TX 76106  
FAX-MKTG. 1 (817) 624-4302  
SECTION  
7-4  
 
RFF332WUT-HHS - Front View  
RFF132WUT - Top View  
RFF332WUT-HHS - Side View  
RLT232WUTFF Top View  
RFF332WUT - Top View  
TRAULSEN  
4401 BLUE MOUND RD.  
PHONE 1 (800) 825-8220  
FT. WORTH, TX 76106  
FAX-MKTG. 1 (817) 624-4302  
SECTION  
7-4  
 
Project  
Quantity  
Item #  
Model Specified:  
CSI Section 11400  
Specifications  
Construction, Hardware and Insulation  
Refrigeration System  
Cabinet exterior front, one piece sides, louver assembly and doors are constructed  
of 20 gauge stainless steel with #4 finish. Cabinet interior and door liners are  
constructed of stainless steel. The exterior cabinet top, back and bottom are  
constructed of heavy gauge aluminized steel. A set of four (4) adjustable 6" high  
stainless steel legs are included.  
A top mounted, self-contained, balanced refrigeration system using R-404A refriger-  
ant is conveniently located behind the one-piece louver assembly. It features large,  
high humidity, interior mounted evaporator coils, coated with a plastic to retard corro-  
sion, bottom mounted electric condensate evaporator, and an automatic preset time  
activated electric defrost. A cord and plug is supplied standard on one section mod-  
els only. Standard operating temperature is -20°F.  
Doors are equipped with a gasket protecting metal door pan, removable plug  
cylinder locks and guaranteed for life cam-lift, gravity action, self-closing metal, glide  
hinges with stay open feature at 120 degrees. Hinges include a concealed switch to  
automatically activate the interior incandescent lighting. Guaranteed for life, work  
flow door handles are mounted horizontally over recess in door which limits  
protrusion from door face into aisleways. Doors have seamless, polished metal  
corners.  
Controller  
The easy to use water resistant INTELA-TRAUL® microprocessor control system is  
supplied standard. Unit is NAFEM Data Protocol communication (NDP) ready.  
Optional hardware required to be NDP compliant. Third party software required for  
network connection. It includes a 3-Digit LED Display, Fahrenheit or Celsius  
Temperature Scale Display Capability, Defrost Lockout Feature and an RS485 data  
port. In addition it includes audio/visual alarms for: Hi/Lo Cabinet Temperature, Door  
Open, Clean Condenser, Evaporator Coil and Discharge Line Sensor Failures, and  
Power Supply Interruption.  
Easily removable for cleaning, vinyl magnetic door gasket assures tight door seal.  
Anti condensate heaters are located behind each door opening.  
Both the cabinet and door(s) are insulated with an average of 2" thick high density,  
non-CFC, foamed in place polyurethane.  
Interior  
Standard interior arrangements include three (3) chrome plated wire shelves per  
section, mounted on shelf pins. Shelves are full-width, and do not have any large  
gaps between them requiring the use of "bridge" or "junior shelves." Recommended  
load limit per shelf should not exceed 225 lbs. Optional tray slides may be  
purchased in combination with, or in lieu of these. Both standard and optional  
interior arrangements are completely installed at the factory.  
DIMENSIONAL DATA  
Net capacity cu. ft.  
Length - overall in.  
Depth - overall in.  
RFF132WUT  
24.2 (686 cu l)  
2978 (75.9 cm)  
35 (88.8 cm)  
32 (81.3 cm)  
RFF232WUT  
51.6 (1462 cu l)  
58 (147.3 cm)  
35 (88.8 cm)  
32 (81.3 cm)  
RFF332NUT  
69.5 (1969 cu l)  
76516 (193.8 cm)  
35 (88.8 cm)  
Warranties  
Depth - over body in.  
32 (81.3 cm)  
Both a one year parts and labor warranty and a five year compressor warranty (self-  
contained models only) are provided standard. An optional 2nd year extended parts  
and labor warranty is also available. In addition the INTELA-TRAUL® control is  
warranted by a two year parts and labor warranty.  
Depth - with door open  
90 degrees in.  
571116 (146.5 cm) 571116 (146.5 cm) 5534 (141.6 cm)  
Clear door width in.  
2118 (53.6 cm)  
2712 (69.9 cm)  
5758 (146.3 cm)  
2118 (53.6 cm)  
2712 (69.9 cm)  
5758 (146.3 cm)  
8314 (211.5 cm)  
2118 (53.6 cm)  
2712 (69.9 cm)  
5758 (146.3 cm)  
8314 (211.5 cm)  
Clear half-door height in.  
Clear full-door height in.  
Height - overall on 6" legs 8314 (211.5 cm)  
FAST FREEZING NOTES:  
Shelf area sq. ft.  
Net Wt. lbs.  
18.8 (1.75 sq m)  
415 (188 kg)  
37.6 (3.49 sq m) 51.9 (4.82 sq m)  
For best results, it is recommended that loading be held to a minimum with more  
frequent use of the freezing process made. Depending on the product variables of  
type, size and placement, together with the desired quantity, the time necessary for  
freezing will be determined.  
705 (320 kg)  
870 (395 kg)  
ELECTRICAL DATA  
Voltage  
208/115/60/1  
208/115/60/1  
208/115/60/1  
Three factors: air temperature, air movement and refrigeration capacity, all  
combine to provide fast freezing. A fourth factor is also important. This is the  
combined effects of product type, size, quantity and placement. The smaller  
the product size and quantity, the faster will its freezing be accomplished. The  
placement of product with adequate spacing also assures faster freezing by allowing  
freer movement of air around it.  
Feed wires with Ground  
Full load amperes  
Wattage1  
4
4
4
8.8  
1830  
22.0  
2928  
22.0  
2928  
REFRIGERATION DATA  
Refrigerant  
R-404A  
R-404A  
R-404A  
BTU/HR H.P.2  
4130 (1 HP)  
2 x 8260 (1 HP)  
2 x 8260 (1 HP)  
NOTES  
NOTE: Figures in parentheses reflect metric equivalents.  
1=Wattage is determined by listed amps X listed volts X an average run time of 70%  
for refrigerators and 80% for freezers.  
2=Based on a 90 degree F ambient and -20 degree F evaporator.  
3=For approximate remote weights deduct 40 lbs. from respective net or gross weight.  
For other information on remote models, please refer to spec sheet 12-2.  
Equipped With One NEMA L14-20P Plug  
(one section model only)  
Full load amps and plug style may vary depending on electrical options  
chosen and condensing unit employed.  
REQUIRED CLEARANCES  
In order to assure optimum performance, the condensing unit MUST have an adequate supply of  
air for cooling purposes. Therefore, the operating location must either have a minimum of 12”  
clearance overhead of the condensing unit or allow for unrestricted air flow at the back of the unit.  
Clearance of at least 12above is required in order to perform certain maintenance tasks.  
NOTE: When ordering please specify: Voltage, Hinging, Door Size, Options and  
any additional warranties. For fast order entry: Fax 1 (800) 765-8728.  
Continued product development may necessitate specification changes without notice.  
Part No. TR35806 (revised 1/07)  
TRAULSEN  
4401 BLUE MOUND RD.  
PHONE 1 (800) 825-8220  
FT. WORTH, TX 76106  
FAX-MKTG. 1 (817) 624-4302  
SECTION  
7-4  
 

Technicolor Thomson Stereo System CS700 User Manual
Technics Stereo System RQT2107 1B User Manual
Technics Stereo System SH KS28 User Manual
Toshiba Network Card S2T User Manual
Toshiba Projection Television TLP S40 SVGA User Manual
Transition Networks Network Card CETTF10XX 200 User Manual
Uniden Telephone DSS 2405 User Manual
ViewCast Computer Drive 240E User Manual
Weed Eater Lawn Mower 438175 User Manual
W W Manufacturing Battery Charger X3 X6 User Manual